Witura WT-1011RC IP 65 Manual de usuario descargar pdf (Pagina 25)

WT-1011RC IP65 GSM Remote Controller

And Alarm S

stem

WT-1011RC IP65 – USER MANUAL – Rev.1.6 – Technical Support: [email protected]

WITURA CORPORATION SDN BHD

To reset the total counter value, you can send the following SMS message to the unit.

Text Command:

*CLA[N]#

N stands for Input number 1 – 2

Example:

When *CLA1# is sent, means the total increment counter value will be reset

The system has the function to activate the relay for a specific time and then be

deactivated for a specific time in a repeating process. To set the opening & closing time

of the relays, you can send the following SMS command to the unit.

Note: This function

only applied in (F2) selectable input function 5 and 6. This function will be disabled under GPRS

Mode.

Text Command for Opening time:

*PWT2#XXXXX

XXXXX stands for 5 digits value: The number of seconds

Text Command for Closing time:

*PWK2#XXXXX

XXXXX stands for 5 digits value: The number of seconds

Example:

Opening time of output 2 is set as 1 minute (*PWT2#00060) and the Closing time as 5

seconds (*PWK2#00005) and function 5 is applied on Input 2. When input 2 triggered,

output relay 2 will be activated for 1 minute and close for 5 seconds and then back on

for 1 minute and close again for 5 seconds and will keep on repeating the process until

the command *RLY2#00000 is issued.

5.7.7 Reset the Total Increment Counter Value

5.7.8 Setting the Function of Opening & Closing time for Output Relay

1 2 ... 20 21 22 23 24 25 26 27 28 29

Sin comentarios

Witura WT-1011RC IP 65 Manual de usuario Pagina 25