Witura WT-1011RC IP 65 Manual de usuario descargar pdf (Pagina 14)

WT-1011RC IP65 GSM Remote Controller

And Alarm S

stem

WT-1011RC IP65 – USER MANUAL – Rev.1.6 – Technical Support: [email protected]

WITURA CORPORATION SDN BHD

The output relay 2 can be programmed to operate at a programmable time. To

program this function, you can send the following commands by SMS message to the

unit.

Text Command to Enable this Function:

*FTRY#3

Note: When this function enabled, functions related to activation of output relay 2 will be disabled

and activation of output relay 2 via SMS will be rejected.

Text Command to Enable the normal Function (5.3.1):

*FTRY#1

Text Command to set the time:

*TSET#SS:MM:HH;

HH = hours, MM = minutes and SS = seconds

Example:

Assume it is 8:30am, you would send following SMS message to the unit.

*TSET#00:30:08;

Text Command to set the Operating time for the outputs:

*SMW#SS,MM,HH,TTTTT,G,R;

HH = hours (2 digits)

MM = minutes (2 digits)

SS = seconds (2 digits)

TTTTT = turn on time in seconds (5 digits)

G = group number 1-8

R = 2 (relay 2)

Example1:

Assume you want output relay 2 to turn on for 30 seconds on 5:30pm, you would send

following SMS message to the unit.

*SMW#00,30,17,00030,1,2;

Example of Returned Message:

#SMW=00,30,17,00030,1,2;

5.4.5 Setting the Operating Time for Output Relay

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Sin comentarios

Witura WT-1011RC IP 65 Manual de usuario Pagina 14