Witura WT-9001 IP65 Manual de usuario descargar pdf (Pagina 10)

WT-9001 IP65 GSM Remote Control And Alarm System

WT-9001 IP65 – USER MANUAL – Rev. 3.4 – Technical Support: technical@witura.com

You should install the WT-9001 in a place where there is GSM signal coming from the

operator you want to use. Check it with a phone before proceeding with the installation.

If you need to install the device in a place with little signal, you may consider using an

external antenna that we may supply as an option to be purchased separately with 5m

cable.

Once the WT-9001 GSM Intercom is turned on, you shall be able to see the system start

up on the LCD screen as shown below…

The system is searching for network…

Once the network is found, it will display OK

Attention: If the system doesn’t shows OK when searching the network, it could be the

SIM card not properly installed. Turn off the unit and check the SIM card, when it is

properly seated in place then reboot the system.

When the system is ready to use it will shows

WT-9001

Settings: >>>>

Wait…

4.3 System Start Up

Signal

Power

Battery

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Sin comentarios

Witura WT-9001 IP65 Manual de usuario Pagina 10